Fog lights Fiat Punto Mk2 rear and front
Buy rear and front Fog light FIAT PUNTO (188)
Fog light: parts for the most common versions of the FIAT Punto II Hatchback (188)
Most popular products: Fog lamp the FIAT PUNTO (188) buy online to reduce replacement cost
Top-selling parts for the FIAT PUNTO in the category Fog lights. Choose a high-quality part from the Fog light kit section for your FIAT 188 PUNTO
JUMASA 39011232 Fog Light
Left, without bulb holder
ALKAR 2905349 Fog Light
Left, without bulb holder
PRASCO FT3404413 Fog Light
Right
PRASCO FT3404414 Fog Light
Left
ALKAR 2906349 Fog Light
Right, without bulb holder
JUMASA 39021232 Fog Light
Right, without bulb holder
MCS 327002823 Fog Light
Left, without bulb holder
ABAKUS 661-2011R-UE Fog Light
Right, without bulb holder, without bulb
ABAKUS 661-2011L-UE Fog Light
Left, without bulb holder, without bulb
TYC 19-0566-05-2 Fog Light
Left
ALKAR 2903228 Fog Light
Left, Right, without bulb holder
VALEO 44553 Fog Light
Left, Right, FOGSTAR, with bulb
VALEO 43352 Fog Light
white, Left, Right, with bulb
TYC 19-5785-11-2 Fog Light
Left, Right
FAST FT86580 Fog Light
Left, Right
ALKAR 2903349 Fog Light
Left, Right, without bulb holder
ABAKUS 661-2003L-UE Fog Light
Left, without bulb
ABAKUS 661-2003R-UE Fog Light
Right, without bulb
TYC 19-5041-05-2 Fog Light
Left, Right, with bulb holder
VAN WEZEL 1619999 Fog Light
Left, Right
Confidence in online shopping! You can return Fiat Punto Mk2 fog lights without explanation within 200 days after purchase and get your money back. How? Just use the Safe Order service on the checkout page. The service cost is only 2,99 €.
Each order from 100 € value of goods, include free shipping within Germany.
*Does not apply to large-size auto parts.
Fog lights the FIAT PUNTO (188) – information on part operation, installation, diagnostics, and service intervals
See the technical documentation for the exact location of the fog lights on FIAT PUNTO (188) car, as it can depend on configuration and manufacturing year of the vehicle. The replacement procedure depends on the axle (the front or rear) where the light is mounted.
To make replacement of the components more comfortable, set the car onto a servicing pit or platform, or lift it using a jack.
Disconnect the negative terminal from the battery in order to avoid short circuit.
Gain access to the light fasteners. For this, you probably need to unbend the mudguard, demount the bumper and remove wheel arch protective covers.
The clips fastening the wheel arch covers are easily damageable, that is why you should act very carefully during demounting. First of all, slightly knock on the clip using the hammer, in order to clean it from dirt stuck on the inner side, then remove its pin and only after this – the fastener itself.
If the FIAT PUNTO (188) car has plastic covers on its bumper, use a plastic wedge for releasing their retainers. This will help to avoid damaging of the car body paintwork.
Apply thin layer of grease on the thread of the fog lights fastening bolts. This will help to prevent corrosion and jamming of the fasteners, which will significantly ease demounting of the light units in the future.
Inspect visually and replace, if necessary, the fog light cover gasket. The worn sealing element is unable to provide light hermeticity. Due to dirt and moisture ingress into the light body, the reflector coating may peel off.
AUTODOC recommends you to necessarily perform the following after replacement of FIAT PUNTO (188) car fog lights
Using a soft cloth, clean the fog lights surfaces from stains left during installation. Light intensity and correctness of its diffusion depend on cleanliness of the light lens.
If the vehicle is used on roads with the poor-quality surface, cover the light glass with a special protective film. It will protect the lens from damages.
Adjust the FIAT PUNTO (188) car fog lights in accordance with car manufacturer recommendations. Only properly adjusted light units provide good observability regardless to weather conditions, and do not dazzle drivers in the oncoming cars.