Battery 7P0915105D

For vehicles with START&STOP function Made in Italy Original Quality according to EU Regulation 461/2010 THE PRINCIPAL BENEFITS OF ECOFORCE AGM VRLA AGM (ABSORBENT GLASS MATERIAL)
- Latest OE technology and quality For vehicles with Brake Energy Regeneration function
- High cranking amperage Frenata
- Extreme charge and discharge acceptance (three to four times longer cycle life than traditional batteries)
- Low self-discharge
- Higher resistance to vibrations than conventional batteries
- Totally maintenance-free
- Leak-proof and Spill-proof

for start-stop vehicles with the highest energy requirements and brake energy recovery, for middle and upper class vehicles up to luxury class, as many as 360,000 engine starts.

This technology uses Absorbing Glass Matt separators which bind the acid better and therefore use the cell volume more effectively than standar batteries. For use especially in vehicles with start-stop technology Here are your advantages of the ROCKET/GLOBAL range at a glance:
- For vehicles with start-stop technology, regenerative braking and many electronic consumers
- 4 times better cycle stability compared to a standard battery
- optimal load capacity during the whole life span
- highest safety for you as completely leakproof, electrolytes locked in the fleece and sustained backfire protection
- maximum coverage of current car pool with few types
- newest technology according to OEM standard
- increased plate pressure in the batteries increases the vibration resistance
- increased plate surface leads to increased starting
capability

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.