Vehicle identification number: 0600387
VW Beetle 1600i 1.6 Mexico Spark plug (46 hp Petrol ACD)
Recommended part replacement interval for your car for the part category Spark plug: every 30.000 km
- Spark Plug: 1 - Earthed Electrode, Nickel Middle Electrode
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Size: M 14 x 1,25
- Required quantity: 4
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Item number: 686S0011
- Manufacturer: RIDEX
- EAN number: 4059191685318
- Condition: New
- Product line: Nickel
- Spark Plug: Nickel-Copper Center Electrode, Nickel mass electrode
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Size: M 14 x 1,25
- Required quantity: 4
- Tightening Torque [Nm]: 28
- Resistor [kOhm]: 6
- Spark Plug Head: Fixed SAE connector
- Item number: 686S0011P
- Manufacturer: RIDEX PLUS
- EAN number: 4066423770964
- Condition: New
-
- Fuel Type: CNG / LPG
- Supplementary Article / Supplementary Info Info 2: Electrode gap must be set for operation on gas
- Replace after km: 15000
- Required quantity: 4
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- External Thread [mm]: 14
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Pitch [mm]: 1,25
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Tightening angle [degrees]: 90
- Item number: 686S0069
- Manufacturer: RIDEX
- EAN number: 4059191571390
- Condition: New
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- External Thread [mm]: 14
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Pitch [mm]: 1,25
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Tightening angle [degrees]: 90
- Item number: 686S0310
- Manufacturer: RIDEX
- EAN number: 4065739013994
- Condition: New
-
- Fuel Type: CNG / LPG
- Supplementary Article / Supplementary Info Info 2: Electrode gap must be set for operation on gas
- Replace after km: 15000
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- External Thread [mm]: 14
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Pitch [mm]: 1,25
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Item number: 686S0070
- Manufacturer: RIDEX
- EAN number: 4059191571413
- Condition: New
- Product line: V-Line
- Spark Plug: Fixed SAE connector, Nickel Middle Electrode, 3 - Earthed Electrode, Interference Suppression 1 kOhm, with gasket seat
- Spanner Size: 16 mm
- External Thread [mm]: 14,0
- Thread Length [mm]: 19,0
- Item number: 686S0320
- Manufacturer: RIDEX
- EAN number: 4065739014557
- Condition: New
- Spark Plug: 1 - Earthed Electrode, Nickel Middle Electrode
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Size: M 14 x 1,25
- Required quantity: 4
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Item number: SKSP-1990010
- Manufacturer: STARK
- EAN number: 4059191393183
- Condition: New
- Spark Plug: 1 - Earthed Electrode, with gasket seat
- Electrode Gap [mm]: 0,71
- Spanner Size: 21
- Thread Length [mm]: 19
- for OE number: 003 159 10 03
- contains article number: 13448
- External Thread Size: M14 x 1,25
- Item number: 13450
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816134503
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
-
- TecDoc Engine Number: ACD
- Required quantity: 4
- Product line: Nickel
- Spark Plug: 1 - Earthed Electrode, Nickel Middle Electrode
- Spanner Size: 20.6 mm
- Thread Length [mm]: 12,7
- Thread Size: M14x1.25
- Connector type: Removable SAE
- Tightening Torque [Nm]: 22
- Diameter [mm]: 14
- Weight [g]: 52
- for OE number: N0178011
- alternative item: -
- Item number: W16FSR
- Manufacturer: DENSO
- EAN number: 0042511030336
- Condition: New
price incl. 19% VAT
excl. delivery costs
-
- Fuel Type: CNG / LPG
- Supplementary Article / Supplementary Info Info 2: Electrode gap must be set for operation on gas
- Replace after km: 15000
- Required quantity: 4
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Size: M 14 x 1,25
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Item number: 0 242 235 663
- Manufacturer: BOSCH
- EAN number: 3165143134085
- Condition: New
- Electrode Gap [mm]: 0,8
- Spanner Size: 20,8
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Size: M 14 x 1,25
- Required quantity: 4
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Item number: 0 242 229 656
- Manufacturer: BOSCH
- EAN number: 3165143134245
- Condition: New
- Product line: Powersport
- Spark Plug: 1 - Earthed Electrode, with gasket seat, Copper Centre Electrode
- Electrode Gap [mm]: 0,9
- Spanner Size: 21 mm
- Quality / Grade: Nickel GE
- Thread Length [mm]: 19
- Spark Position [mm]: 5
- Thread Size: M14x1.25
- Connector type: M4 / SAE
- Required quantity: 4
- Packing Type: Box
- Technical Information Number: N12YC
- Tightening torque from [Nm]: 25
- Tightening torque to [Nm]: 30
- Packaging length [cm]: 8,85
- Packaging width [cm]: 2,6
- Packaging height [cm]: 2,35
- Projection [mm]: 3
- Item number: OE015/T10
- Manufacturer: CHAMPION
- EAN number: 5010874507609
- Condition: New
3.0 mm core nose projection
-
- Fuel Type: CNG / LPG
- Supplementary Article / Supplementary Info Info 2: Electrode gap must be set for operation on gas
- Replace after km: 15000
- Product line: Q+, original equipment manufacturer quality
- Spark Plug: 1 - Earthed Electrode
- Electrode Gap [mm]: 0,7
- Length [mm]: 126
- Packaging width [cm]: 8,5
- Packaging height [cm]: 2,4
- Packaging Depth [cm]: 2,4
- Item number: V99-75-0011
- Manufacturer: VEMO
- EAN number: 4046001273643
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Spark Plug: with gasket seat, 3 - Earthed Electrode
- Electrode Gap [mm]: 0,8
- Spanner Size: 21
- Thread Length [mm]: 19
- for OE number: 101 000 007 AD
- External Thread Size: M14 x 1,25
- Item number: 13509
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816135098
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Spark Plug: with gasket seat, 3 - Earthed Electrode
- Electrode Gap [mm]: 0,8
- Spanner Size: 21
- Thread Length [mm]: 19
- contains article number: 13510
- External Thread Size: M14 x 1,25
- Item number: 13512
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816135128
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
price incl. 19% VAT
excl. delivery costs
- Spark Plug: with gasket seat, 3 - Earthed Electrode
- Electrode Gap [mm]: 0,8
- Spanner Size: 21
- Thread Length [mm]: 19
- for OE number: 101 000 007 AD
- contains article number: 13507
- External Thread Size: M14 x 1,25
- Item number: 13508
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816135081
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
-
- Required quantity: 4
- Alternatively
- Product line: Aerovantage Spoiler
- Spark Plug: 1 - Earthed Electrode, with gasket seat
- Electrode Gap [mm]: 0,9
- Spanner Size: 21 mm
- Quality / Grade: Ti Poly-V
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Size: M14x1.25
- Connector type: M4 / SAE
- Packing Type: Box
- Technical Information Number: CET8
- Tightening torque from [Nm]: 25
- Tightening torque to [Nm]: 30
- Packaging length [cm]: 8,85
- Packaging width [cm]: 2,6
- Packaging height [cm]: 2,35
- Resistor from [kOhm]: 3
- Resistor to [kOhm]: 10
- Projection [mm]: 1,5
- Item number: CET8
- Manufacturer: CHAMPION
- EAN number: 4044197906833
- Condition: New
1.5 mm core nose projection
-
- Required quantity: 4
- Alternatively
- Spark Plug: 1 - Earthed Electrode, with gasket seat
- Electrode Gap [mm]: 0,9
- Spanner Size: 21 mm
- Quality / Grade: Poly-V Tit
- Supplementary Info: ULTRA TITAN
- Thread Length [mm]: 19
- Thread Size: M14x1,25
- Connector type: SAE / M4
- Tightening torque from [Nm]: 20
- Tightening torque to [Nm]: 30
- Resistor from [kOhm]: 3
- Resistor to [kOhm]: 10
- Item number: UPT8
- Manufacturer: BERU
- EAN number: 4044197961153
- Condition: New
- Electrode Gap [mm]: 0,9
- Spanner Size: 20,8
- Thread Length [mm]: 19
- Spark Position [mm]: 3
- Thread Size: M 14 x 1,25
- Required quantity: 4
- Tightening Torque [Nm]: 28
- Number of pins: 1
- Item number: 0 242 230 599
- Manufacturer: BOSCH
- EAN number: 2230844581900
- Condition: New
price incl. 19% VAT
excl. delivery costs
-
- Electrode Gap [mm]: 8
- TecDoc Engine Number: ACD
- Spark Plug: Unscrewable SAE connector, Nickel Middle Electrode, 1 - Earthed Electrode, no interference suppression, with gasket seat
- Spanner Size: 20,8 mm
- Thread Length [mm]: 19,0
- Spark Position [mm]: 4,5
- Thread Size: M14 x 1,25
- Item number: 2285
- Manufacturer: NGK
- EAN number: 0087295122853
- Condition: New
- 1
- 2
- 3