QUINTON HAZELL QG2100 Bellow, steering Duraboot

Fitting Instruction Fitting Instruction 1 Remove the road wheel and hub. Slacken and remove the 1 Remove the road wheel and hub. Slacken and remove the track rod end retaining nut. Cut off the old boot, don't track rod end retaining nut. Cut off the old boot, don't pull pull over the track rod end. over the track rod end. 2 Pull the swivel pin towards you and place cone cover 2 Pull the swivel pin towards you and place cone cover over the pin. over the pin. 3 Lubricator the fitting cone and the inside of the new 3 Lubricator the fitting cone and the inside of the new boot with cone spray. boot with cone spray. 4 Pull larger opening of boot over the cone first and then 4 Pull larger opening of boot over the cone first and then ease the small opening over the cone and into position. ease the small opening over the cone and into position. 5 Remove the cone and top up the steering rack with 5 Remove the cone and top up the steering rack with correct lubricant (EP90 or similar>) via the small correct lubricant (EP90 or similar>) via the small opening. opening. 6 Secure one end of the boot with the fixing clip. 6 Secure one end of the boot with the fixing clip. 7 Secure the other end with the remaining fixing clip. 7 Secure the other end with the remaining fixing clip. 8 Refit the track rod end onto the control arm and tight 8 Refit the track rod end onto the control arm and tight en nut to the correct torque. Replace the road wheel. en nut to the correct torque. Replace the road wheel.