Audi A6 C8 Avant RS6 Mild Hybrid quattro Suspension kit, coil springs / shock absorbers (600 hp Petrol/Electric DJPB)

Note DCC: The installation of this suspension into cars Only for front strut diameter ø 48,5mm. Only for vehicles with RS suspension plus and dynamic ride Please note additional information and vehicle-specific control technical notes! with an electronic damping adjustment (DCC , Magnetic Ride etc.) must be done in an authorized (Audi - , VW-, etc.) workshop. The signal of the electronic damping adjustment in the display has to be deactivated (e.g. by interference-free complex resistance plugs which are connected to the valve connectors of the front and rear damping adjustment).

Incl. DCC cancellation kit Note DCC: The installation of this suspension into cars Only for front strut diameter ø 48,5mm. Only for vehicles with RS suspension plus and dynamic ride Please note additional information and vehicle-specific control technical notes! with an electronic damping adjustment (DCC , Magnetic Ride etc.) must be done in an authorized (Audi - , VW-, etc.) workshop. The signal of the electronic damping adjustment in the display has to be deactivated (e.g. by interference-free complex resistance plugs which are connected to the valve connectors of the front and rear damping adjustment).

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.