Water pump 94810601103

'Improved design for longer service life: MEYLE-HD parts 4-year warranty on all MEYLE-HD parts. MEYLE provides a 100,000-mile guarantee for all MEYLE water Simply lasts longer: MEYLE-HD water pump with extreme hard Water pump bearing in OE quality, according to application: 4-point roller/ball: Best distribution of high radial deliver enhanced durability. Compared to OE, MEYLE-HD is Engineered and quality approved in Germany. pumps and a 4-year warranty for MEYLE-HD water pumps. wearing SiC/SiC mechanical seal. Resistant against abrasive contamination. forces as well as increased axial support or Angular technically improved with reinforced inner parts, using The 100,00 mile warranty requires the cooling system to be contact: Absorption of axial and medium radial flushed before installation. higher quality materials or optimized design solution. Housing made of stainless steel, resistant to high forces as well as increased axial support. temperature.

Products and spare parts supplied by us are only intended for the designated use. Installation may only be carried out by trained specialist personnel. Our products are not always supplied with installation instructions. Improper installation or inappropriate use may lead to the exclusion of warranty.

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.