Trailing arm / suspension arm bush, Suspension arm, Control arm repair kit 7700430765

Important: Observe Fitting Instructions

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.

'Improved design for longer service life: MEYLE-HD parts 4-year warranty on all MEYLE-HD parts. Better than OE: MEYLE-HD bushings with optimized inner deliver enhanced durability. Compared to OE, MEYLE-HD is Engineered and quality approved in Germany. sleeve profile withstand greater forces and provide a longer life and performance. technically improved with reinforced inner parts, using higher quality materials or optimized design solution.

When using JTC1113 or JTC1114 instead of JTC334 or JTC335, i t is necessary to replace the transverse control arms on bot h sides, as well as the stabilizer bar and its fastening. The new parts cannot be combined with the old ones.

When using JTC1113 or JTC1114 instead of JTC334 or JTC335, i t is necessary to replace the transverse control arms on bot h sides, as well as the stabilizer bar and its fastening. The new parts cannot be combined with the old ones.

With ball joint