Vehicle identification number: 0603AQL
High pressure line, Air conditioning, High- / low pressure line 1J0820721D
All spare parts in the list below are equivalent to OEM number 1J0 820 721D:
- 1J0 820 721D (original number of VW)
- 1J0 820 721D (original number of AUDI)
- 1J0 820 721D (original number of SEAT)
- 1J0 820 721D (original number of SKODA)
- Heating / Cooling: from air conditioning compressor to condenser
- Supplementary Article / Supplementary Info: with gaskets / seals, with pipe
- Supplementary Article / Supplementary Info Info 2: High Pressure Side
- Seal Material: HNBR (hydrogenated nitrile butadiene rubber)
- Usable for refrigerant: R134a
- Item number: 119 856
- Our price: 54,63 €
- Manufacturer: TOPRAN
- EAN number: 4063926461078
- Condition: New
- Reference number OEM: 1J0820721D
Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
price incl. 19% VAT
excl. delivery costs
- Supplementary Info: Original VEMO Quality
- Heating / Cooling: from air conditioning compressor to condenser
- Item number: V15-20-0029
- Our price: 58,14 €
- Manufacturer: VEMO
- EAN number: 4046001426179
- Condition: New
- Reference number OEM: 1J0820721D
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.