Nissan NV400 Van dCi 125 RWD Lambda sensor (125 hp Diesel M9T 690)

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

Lambda sensor socket, flexible grip,22mm, 240mm •optional 6 and 12 point (duplicate socket)

•special socket for assembling and dismantling of stuck Lambda sensors that are difficult to access

•for almost all vehicle types

•180° freely-revolving joint

•time-saving to work with, even for hard-to-reach Lambda sensors

•prevents disassembly and assembly of protective shield

•flat and half-opened design

•for professional and damage-free use

•universal application and highly durable

•chrome vanadium

HAZET Lambda probe socket 4680-1 ∙ Square, hollow 12.5 mm •For lambda probes on NISSAN ∙ FORD ∙ VOLKSWAGEN ∙ SEAT ∙ (1/2 inch) ∙ Outside hexagon profile ∙ 22 mm ŠKODA etc.

•Optimal fit to the 6-point profile of the lambda probe

•Long design

•Surface: chrome-plated

•Made in Germany

•Drive: Square, hollow 12.5 mm (1/2 inch)

•Output: Outside hexagon profile

•Wrench size: 22 mm

•Dimensions / length: 92 mm

•Diameter d1 (output side): 30.4 mm

•Diameter d2 (drive side): 25 mm

•Net weight: 0.23 kg

•For manual operation