Mazda 2 DH 1.6 MZ-CD Lambda sensor (90 hp Diesel Y406)

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

HAZET Lambda probe socket 4680-1 ∙ Square, hollow 12.5 mm •For lambda probes on NISSAN ∙ FORD ∙ VOLKSWAGEN ∙ SEAT ∙ (1/2 inch) ∙ Outside hexagon profile ∙ 22 mm ŠKODA etc.

•Optimal fit to the 6-point profile of the lambda probe

•Long design

•Surface: chrome-plated

•Made in Germany

•Drive: Square, hollow 12.5 mm (1/2 inch)

•Output: Outside hexagon profile

•Wrench size: 22 mm

•Dimensions / length: 92 mm

•Diameter d1 (output side): 30.4 mm

•Diameter d2 (drive side): 25 mm

•Net weight: 0.23 kg

•For manual operation

Supplement set for SAC coupling tool set (4 fixing points), •accuracy of fit through high-precision CNC components

5 pcs •required for pre-tensioning the pressure plate before removing and installing SAC clutches with 4-hole pitch

•sturdy design

•chrome plated

•special tool steel



Application range: 4-hole pressure plate necessary for e.g. Mercedes (169) from the year of manufacture 2004 (A-class), Opel Insignia etc.

Application: HAZET Lambda probe socket 4680-3 ∙ Square, hollow 12.5 mm (1/2 inch) ∙ Outside hexagon profile ∙ 22 mm For lambda probe (Wrench size 22 mm) on VW, AUDI

•Choice of Inside square drive 12.5 = 1/2″ or Outside hexagon 32 mm

•Long design

•Surface: chrome-plated

•Made in Germany

•Drive: Square, hollow 12.5 mm (1/2 inch)

•Output: Outside hexagon profile

•Wrench size: 22 mm

•Dimensions / length: 110 mm

•Diameter d1 (output side): 41 mm

•Diameter d2 (drive side): 34.4 mm

•Net weight: 0.51 kg

•For manual operation

Universal 2-arm puller, 6" •For removing e.g. inner bearing, outer bearing, ball bearing, etc.

•It can be used as interior and exterior extractor



The two-armed BRILLIANT TOOLS universal extractor BT631022 can be used as an interior and exterior extractor. The extractor has a clamping width of 60 mm to 12 cm and a clamping height of 13 cm, making it the best option for removing discs, sprockets, ball bearings, pulleys, gears and much more.