Audi A3 8P Sportback RS3 2.5 quattro Service kit & filter set (340 hp Petrol CEPA)
Recommended part replacement interval for your car for the part category Service kit & filter set: every 15.000 km
- Supplementary Article / Supplementary Info: with gaskets / seals
- Filter type: Filter Insert, In-Line Filter
- Height [mm]: 125, 165
- Inner Diameter [mm]: 31
- Diameter [mm]: 64, 60
- Height 1 [mm]: 80
- Diameter 1 [mm]: 55
- Item number: 4055F34662
- Our price: 20,28 €
- Manufacturer: RIDEX
- EAN number: 4066016867750
- Condition: New

- Quantity Unit: Set
- Filter type: Filter Insert, In-Line Filter
- Diameter [mm]: 63,5, 56
- Height [mm]: 125,0
- Inner Diameter 2 [mm]: 21
- Overall Length [mm]: 165
- Multi-piece: two-piece
- Item number: 4055F34662P
- Our price: 27,12 €
- Manufacturer: RIDEX PLUS
- EAN number: 4069197077789
- Condition: New
- Supplementary Article / Supplementary Info: with gaskets / seals
- Filter type: Filter Insert, In-Line Filter
- Height [mm]: 125, 165
- Inner Diameter [mm]: 31
- Diameter [mm]: 64, 60
- Height 1 [mm]: 80
- Diameter 1 [mm]: 55
- Item number: SKFS-188114674
- Our price: 20,28 €
- Manufacturer: STARK
- EAN number: 4066016867743
- Condition: New
- for OE number: FKVAG012
- Item number: FKVAG012
- Our price: 51,49 €
- Manufacturer: MEAT & DORIA
- EAN number: 808888997804
- Condition: New
- for OE number: FKVAG015
- Item number: FKVAG015
- Our price: 104,99 €
- Manufacturer: MEAT & DORIA
- EAN number: 808888997810
- Condition: New
- Fitting Position: Rear Axle
- Supplementary Article / Supplementary Info: with oil drain plug
- Clutch Type: for wet clutch
- Supplementary Article / Supplementary Info Info 2: without filter, with oil quantity for standard oil change, without strainer
- Recommended change interval [km]: 30000
- Recommended change interval [years]: 3
- Clutch ID: HALDEX GEN IV / 4, HALDEX GEN V / 5
- Capacity [litre]: 0,85
- Oil manufacturer recommendation: G 060 175 A2
- Item number: V10-6603
- Our price: 54,99 €
- Manufacturer: VAICO
- EAN number: 4062375255429
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

- Manufacturer Restriction: Haldex Gen. II
- Filter type: Filter Insert
- Inner Diameter [mm]: 12
- Height [mm]: 55
- Diameter [mm]: 46
- Clutch ID: Haldex Gen II
- External Thread Size: M48 x 1,5
- Gasket inside diameter [mm]: 45
- Gasket outside diameter [mm]: 51
- Weight [kg]: 1,07
- Item number: 180039
- Our price: 56,99 €
- Manufacturer: FEBI BILSTEIN
- EAN number: 4054224800393
- Condition: New
These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
price incl. 19% VAT
excl. delivery costs
- Fitting Position: Rear Axle
- Supplementary Article / Supplementary Info: with oil drain plug
- Quantity Unit: Set
- Clutch Type: for wet clutch
- Filter type: with housing cover, Filter Insert
- Supplementary Article / Supplementary Info Info 2: with bolts / screws, with seal ring, with oil quantity for standard oil change, without strainer
- Recommended change interval [km]: 30000
- Recommended change interval [years]: 3
- Clutch ID: HALDEX GEN II / 2
- Capacity [litre]: 0,85
- Item number: V10-5753
- Our price: 85,99 €
- Manufacturer: VAICO
- EAN number: 4062375195091
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: Rear Axle
- Supplementary Article / Supplementary Info: with strainer, with oil drain plug
- Quantity Unit: Set
- Clutch Type: for wet clutch
- Filter type: with housing cover, Filter Insert, Screen Filter
- Supplementary Article / Supplementary Info Info 2: with bolts / screws, with seal ring, with oil quantity for standard oil change
- Recommended change interval [km]: 30000
- Recommended change interval [years]: 3
- Clutch ID: HALDEX GEN II / 2
- Capacity [litre]: 0,85
- System Generation: 2
- Item number: V10-5753-XXL
- Our price: 100,49 €
- Manufacturer: VAICO
- EAN number: 4062375418619
- Condition: New
price incl. 19% VAT
- Fitting Position: Rear Axle
- Clutch Type: for wet clutch
- Filter type: with housing cover, Filter Insert, Screen Filter
- Clutch ID: HALDEX GEN IV / 4
- Recommended change interval [km]: 30000
- Supplementary Article / Supplementary Info: with oil drain plug, with strainer
- Quantity Unit: Set
- Recommended change interval [years]: 3
- Supplementary Article / Supplementary Info Info 2: with bolts / screws, with seal ring, with oil quantity for standard oil change
- Capacity [litre]: 0,85
- Item number: V10-5600-XXL
- Our price: 127,49 €
- Manufacturer: VAICO
- EAN number: 4062375418602
- Condition: New
price incl. 19% VAT
- Fitting Position: Rear Axle
- Supplementary Article / Supplementary Info: with oil drain plug
- Clutch Type: for wet clutch
- Filter type: with housing cover, Filter Insert
- Clutch ID: HALDEX GEN IV / 4
- Recommended change interval [km]: 30000
- Quantity Unit: Set
- Recommended change interval [years]: 3
- Supplementary Article / Supplementary Info Info 2: with bolts / screws, with seal ring, with filter, with oil quantity for standard oil change, without strainer
- Capacity [litre]: 0,85
- Item number: V10-5600
- Our price: 87,49 €
- Manufacturer: VAICO
- EAN number: 4062375166305
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- for OE number: FKVAG013
- Item number: FKVAG013
- Our price: 40,99 €
- Manufacturer: MEAT & DORIA
- EAN number: 808888997806
- Condition: New