Citroen C4 Grand Picasso Mk1 1.8 i 16V CNG Axle bushes (117 hp CNG )
- Fitting Position: Rear
- Mounting Type: Rubber-Metal Mount
- Diameter [mm]: 81
- Inner Diameter [mm]: 14
- Height [mm]: 79
- Item number: EM4743
- Manufacturer: QUINTON HAZELL
- EAN number: 5050438442496
- Condition: New
- Fitting Position: Front Axle
- Mounting Type: Rubber-Metal Mount
- for OE number: 1806A0
- Item number: RH11-2175
- Manufacturer: REINHOCH
- EAN number: 5901655206234
- Condition: New
- Fitting Position: Rear Axle, Front
- Diameter [mm]: 14,3
- Length [mm]: 78,5
- Height [mm]: 79
- Packaging length [cm]: 10
- Packaging width [cm]: 8
- Packaging height [cm]: 7,9
- Packing Type: Bag
- Item number: PE-SB-8839
- Manufacturer: MOOG
- EAN number: 4044197644452
- Condition: New
- Fitting Position: Rear Axle, outer, Left, Right
- Inner Diameter [mm]: 14
- Required quantity: 2
- Diameter [mm]: 81
- Height [mm]: 79
- Item number: 8500 28837
- Manufacturer: TRISCAN
- EAN number: 5710476041210
- Condition: New
price incl. 19% VAT
- Height [mm]: 78,5
- Width [mm]: 81
- Weight [g]: 350
- Fitting Position: Rear Axle both sides
- Inner Diameter [mm]: 14,2
- Shore-A hardness value, base body: 60
- Item number: 53912
- Manufacturer: BIRTH
- EAN number: 1000000271858
- Condition: New
- Fitting Position: Rear Axle
- Axle alignment required after fitting
- Item number: V22-0412
- Manufacturer: VAICO
- EAN number: 4046001704369
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.